I sent you a couple of PMs over the last 2 weeks but no answer. Also please advise on why do you recommend not splitting up proxies for two different uses? Ex. I subscribe to 50 ports but use 25 in one GSA SER install and 25 in another as opposed to using all 50 ports in one install?
Ok, so I've finally got my answer almost 2 months later. I was hoping someone would post a review on here about this proxy service but no luck. I've been using this service for almost 2 months now and I can honestly report, it's pretty darn good. I've also used reverseproxies service too and all things being equal, (monthly cash outlay, performance, technical difficulties, customer support) I'm choosing Proxyrotor. As long as this guy keeps up what he's doing, this will continue to be a top notch service.
Just checking in to see if I understood correctly. The amount of ports you signup for is the amount of different IPs you hace access at the same time, and each port can be used with up to 10 threads at a time. In my software, all that I will have to do is to point to those IP:PORT you will provide according to the plan I buy.
Just ordered a 10 port subscription, I'm using them on a VPS with Gscraper.
I have authorized my IP, and imported the ports into Gscraper, but my scarping numbers are bad. I've been scraping for more than 30 minutes at 100 threads and haven't scrapped more than 800 urls.
I have disabled the "Skip and change" setting in Gscraper like you mentioned at the start of this thread.
It's like the ports aren't working at all, I get the initial results from the first minute and starting Gscraper and then nothing happens.
Comments
I send you 2 pm's in the last week but still waiting for a response, please
Left you a message on Skype and your support email
Cheers!
in your case to be exact splitting is actually adviced.
ps: sorry for some reason i missed your pms.
Just ordered a 10 port subscription, I'm using them on a VPS with Gscraper.
I have authorized my IP, and imported the ports into Gscraper, but my scarping numbers are bad. I've been scraping for more than 30 minutes at 100 threads and haven't scrapped more than 800 urls.
I have disabled the "Skip and change" setting in Gscraper like you mentioned at the start of this thread.
It's like the ports aren't working at all, I get the initial results from the first minute and starting Gscraper and then nothing happens.
What could be going on?