Hi @Sven .. after running v6.88 for a while now .. it seems it takes realy alot of cpu usage on some parts .. ser hangs for a while and then comes back again
Comments
evergreenman
Mines flying at 188LPM
KayKay
will try new version if it changes ,)
Sven www.GSA-Online.de
yea there was a minor bug in 6.88...should be fine on 6.89 (released earlier today).
skoh
I still notice poor performance on 6.89. I'm not complaining but I am a power user of GSA and notice even the little subtleties like this
gooner SERLists.com
I agree with @skoh, SER running very laggy in 6.89
KayKay
its running better than the old one for sure
gooner SERLists.com
I don't know man, I'm still getting a lot of lag and "not responding" running SER on a 32gb dedicated with 600 threads.
skoh
edited October 2013
^ same across multiple dedi's but not that many threads lol
tommy99
same here
nawshale Sales & Tech Support at www.SERVerifiedLists.com
same here very laggy
theseo1
edited October 2013
Experiencing a similar issue in 6.89.
After importing a list of around 2000 targets manually into a project than ran before, GSA stops to 5 threads after around 500 processed and I get the 'Attention - no more targets' message. Tried it with a different project as well, same problem. if I check (both pre and after) setting the status to inactive for remaining target URLs, it shows none left. They're also not resumed when you re-active the project.
After running on 6.68, loading the project, re-loading the articles (as they were empty, I think due to the usage of article manager before), everything goes smooth.
Comments
After importing a list of around 2000 targets manually into a project than ran before, GSA stops to 5 threads after around 500 processed and I get the 'Attention - no more targets' message. Tried it with a different project as well, same problem. if I check (both pre and after) setting the status to inactive for remaining target URLs, it shows none left. They're also not resumed when you re-active the project.
After running on 6.68, loading the project, re-loading the articles (as they were empty, I think due to the usage of article manager before), everything goes smooth.